Power amplifier XP1000

Power amplifier The XP power amplifier series includes 5 models with different outputs ranging from 700W (stereo, 8ohms) to 100W (stereo, 8ohms). The broad choice of power output the XP series provides means you can select a model that will ideally match the power requirements of your application. For even further flexibility all models can operate in 3 modes: in the stereo mode the two channels are independent; the parallel (dual mono) mode allows a single mono input signal to drive both channels and two independent speaker systems; and in the bridge mode, both channels work together to deliver maximum power. The environmentally friendly XP series amplifiers also use lead-free parts. XP1000 110W + 110W (8 ohms, 20 Hz - 20 kHz General specifications ModelXP7000XP5000XP3500XP2500XP1000Power bandwidth10Hz-40kHzTotal harmonic distortionLess than 0.1% (20Hz-20kHz, half power)Intermodulation distortionLess than 0.1% (60Hz:7kHz=4:1; Halfpower)Frequency response0, +0, -1dB; 20Hz-50kHzS/N ratioMore than 104dBMore than 103dBMore than 102dBMore than 100dBMore than 96dBResidual output noiseLess than -70dBu (DIN AUDIO)CrosstalkLess than -70dBDamping factorMore than 350More than 200Maximum voltage gain32dB/26dB/Variable (Selectable)Input sensitivitySwitch Position: +4dBu+4dBu+4dBu+4dBu+4dBu+4dBuSwitch Position: 26B+13.7dBu+12.2dBu+10.7dBu+9.2dBu+5.2dBuSwitch Position: 32dB+7.7dBu+6.2dBu+4.7dBu+3.2dBu-0.8dBuMaximum input voltage+22dBuProcessorsHPF (20Hz/55Hz/OFF, 12dB/Oct)I/O connectorsLine input/output portsXLR-3-31 type/ch, Euroblock connector/chSpeaker output portsSPEAKON/ch, 5-way binding post/chControl portsD-sub15pin x1Protection circuitLoad protectionPOWER switch ON/OFF mute, DC-fault (Amplifier shuts down automatically), Clip limiting (THD ≥ 0.5%)POWER switch ON/OFF mute, DC-fault (Output relay off; Restored automatically), Clip limiting (THD ≥ 0.5%)Amplifier protectionThermal (Mute the output; heatsink temp ≥ 90°C; Operation not restored automatically), VI limiter (Limit the output, RL ≤ 1ohm)Power supply protectionThermal (Amplifier shuts down automatically; heatsink temp ≥ 100°C)Thermal (Amplifier shuts down automatically; transfomer temp ≥ 130°C; Restored automatically)Amplifier classEEEngineCoolingDual variable-speed fanSingle variable-speed fan